Before filling nail holes in drywall with joint compound, dent the surface around the nail hole slightly using a hammer with a rounded head or a special drywall hammer, so the joint compound will adhere and sand smooth.

Option #1: Rehab Old Wall: If the wall has plaster or drywall behind the paneling and the paneling wasnвЂ™t glued to the wall surface, you may be able to remove the paneling and rehab the old wall surface using drywall joint compound.Mark where each molding came from on the back, and save them for reuse later. Use a hammer and flat pry bar to take off any quarter round, baseboards, crown molding, chair rail, or door and window casings. If the moldings and trim are installed over the paneling, as is usually the case, start by removing them. Step #7: Paint Paneling: At long last youвЂ™re ready to roll two coats of high quality, latex wall paint on the paneling!.

Step #6: Prime Paneling: Apply a coat of latex wall primer to keep the joint compound from showing through.

Step #5: Sand Paneling: Once the joint compound has dried, sand the surface smooth with medium grit sandpaper.

Continue applying the compound in thin layers until the cracks are completely filled.

Step #4: Additional Coats: Allow the joint compound to dry and shrink overnight before applying each additional coat.

DonвЂ™t use spackling compound, which isnвЂ™t durable enough, or caulk, which wonвЂ™t sand smooth. Use a putty knife to apply a thin layer of joint compound in the cracks.

Step #3: Fill Grooves: After the primer dries, fill in the grooves in the paneling with standard drywall joint compound.Step #2: Prime Paneling: Next, apply an even coat of primer to give a uniform surface for the filler to stick to.Step #1: Sand Paneling: Start by sanding the surface with medium (120 grit) sandpaper to remove the glossy finish.

Push video wallpaper 3.49 crack